Skip to content
Free shipping on all US domestic orders (excluding oversized items). No minimum purchase; even small items ship free.
Free shipping on all US domestic orders (excluding oversized items). No minimum purchase; even small items ship free.

Zamp Z-20 Series Dirt Replacement Shields

by ZAMP
Original price $41.50 USD - Original price $54.50 USD
Original price $41.50 USD
$41.50 USD

$41.50 USD - $54.50 USD
Current price $41.50 USD
Color: Clear
fast_free_shipping
easy_returns
secure_checkout
satisfaction_guraranteed

About this item:

  • These DIRT-specific Z-20 Series Shields are built to seal and prevent dirt and debris from entering your helmet through the top of the shield.

  • Zamp-Racing recommends that you periodically change shields for better vision and safety.

  • Manufacturer part number:
    • HASZ20CLDIRT (Clear)
    • HASZ20CLAFDIRT (Clear Anti-Fog)
  • ZAMP Z-20 Series DIRT Shield Fitment Guide:
    • Zamp RZ-36
    • Zamp RZ-36 Dirt
    • Zamp RZ-36 Air
    • Zamp RZ-37Y Youth
    • Zamp RZ-42Y Youth
    • Zamp RZ-42Y Youth Graphic
    • Zamp RZ-56
    • Zamp RZ-56 Air
    • Zamp RZ-59
    • Zamp RZ-60
    • Zamp RZ-60V
    • Zamp RZ-62
    • Zamp RZ-62 Graphic
    • Zamp RZ-62 Air
    • Zamp RZ-64C
    • Zamp RZ-65D Graphic
    • Zamp RZ-70E Switch
    • Zamp RL-70E Switch 
  • Z-20 Anti-Fog vs Standard Shield Comparison video:

  • NOTE: DO NOT USE power tools or overtighten screws when changing shields.

  • Step 1 - Lay a towel on a flat surface and set the helmet on it.

  • Step 2 - Remove the shield pivot tensioners on each side. (This is the smaller crew on the sides of the shield.)

  • Step 3 - Remove the shield pivot screws on each side. (This is the larger screw on the sides of the shield. For best results, we suggest using a quarter to loosen/tighten these screws).

  • Step 4 - Remove the shield. We suggest using a soft cloth towel to wipe down the rubber seal as well as where the shield mounts to the helmet for best results.

  • Step 5 - Place the new shield on the helmet. There are two white washers that go between the shield and helmet, make sure these are in place before re-installing the shield pivot screws.

  • Step 6 - Hand thread the shield pivot screws to hold the shield in place. Once hand threaded, use a quarter to tighten until snug with the helmet shell. Do not over-tighten.

  • Step 7 - Hand thread the shield pivot tensioners, then tighten to desired tension for shield movement.

Customer Reviews: