Skip to content
Free shipping on all US domestic orders, excluding a few oversized items. There is no minimum purchase, and even the small stuff ships free. Most orders ship the same day!
Free shipping on all US domestic orders, excluding some seat brands. There is no minimum purchase, and even the small stuff ships free.

Zamp Z-20 Series Dirt Replacement Shields

by ZAMP
Original price $41.50 USD - Original price $54.50 USD
Original price $41.50 USD
$41.50 USD

$41.50 USD - $54.50 USD
Current price $41.50 USD
Color: Clear

About this item:

  • These DIRT-specific Z-20 Series Shields are built to seal and prevent dirt and debris from entering your helmet through the top of the shield.

  • Zamp-Racing recommends that you periodically change shields for better vision and safety.

  • Manufacturer part number:
    • HASZ20CLDIRT (Clear)
    • HASZ20CLAFDIRT (Clear Anti-Fog)
  • ZAMP Z-20 Series DIRT Shield Fitment Guide:
    • Zamp RZ-36
    • Zamp RZ-36 Dirt
    • Zamp RZ-36 Air
    • Zamp RZ-37Y Youth
    • Zamp RZ-42Y Youth
    • Zamp RZ-42Y Youth Graphic
    • Zamp RZ-56
    • Zamp RZ-56 Air
    • Zamp RZ-59
    • Zamp RZ-60
    • Zamp RZ-60V
    • Zamp RZ-62
    • Zamp RZ-62 Graphic
    • Zamp RZ-62 Air
    • Zamp RZ-64C
    • Zamp RZ-65D Graphic
    • Zamp RZ-70E Switch
    • Zamp RL-70E Switch 
  • Z-20 Anti-Fog vs Standard Shield Comparison video:

  • NOTE: DO NOT USE power tools or overtighten screws when changing shields.

  • Step 1 - Lay a towel on a flat surface and set the helmet on it.

  • Step 2 - Remove the shield pivot tensioners on each side. (This is the smaller crew on the sides of the shield.)

  • Step 3 - Remove the shield pivot screws on each side. (This is the larger screw on the sides of the shield. For best results, we suggest using a quarter to loosen/tighten these screws).

  • Step 4 - Remove the shield. We suggest using a soft cloth towel to wipe down the rubber seal as well as where the shield mounts to the helmet for best results.

  • Step 5 - Place the new shield on the helmet. There are two white washers that go between the shield and helmet, make sure these are in place before re-installing the shield pivot screws.

  • Step 6 - Hand thread the shield pivot screws to hold the shield in place. Once hand threaded, use a quarter to tighten until snug with the helmet shell. Do not over-tighten.

  • Step 7 - Hand thread the shield pivot tensioners, then tighten to desired tension for shield movement.

Customer Reviews: