Staff Answer
Nov 12, 2026 - 10:06 AM
Install the Zamp Z-Tech 8A helmet hardware on a helmet with M6 inserts. Zamp's 8A manual says to remove the black cap from the back of the helmet kit, set the baseplate against the shell centered on the M6 insert, then put the M6 xxxx through the post with blue thread locker on the end.
Tighten the xxxx snugly without cross-threading and let the thread locker dry. The center post of the 8A helmet kit must point toward the back of the helmet. More detail is in our Zamp Z-Tech 8A review.
